Rotary Toolpath leaves stock.

[Linus_Follinger]

i can´t get the rotary toolpath to go all the way in. (finnish pass).
it leaves a lot och stock depending on my stepover. 

is this not possiable to machine a little staircase like this with rotary?

its not shown in the video but i can machine the OD without trouble.

[LibertyMachine]

I would expect that to work as it is. Try setting it to "Circular Passes" instead.

On the other hand, for a part such as this, I'd likely use 2D Contour > Wrapped, but that would also necessitate a model split and some voodoo.

[seth.madore]

whoops, that's me above. 

[Linus_Follinger]

Sadly circular leaves an even layer and only finish a little portion.

But thanks for the Fast answer @seth.madore  !!

ill try the countour- wrap toolpath with split body

im just trying to get familiar with rotary basics.

for now ill run the part in the 3 - axis