reorient millturn axis

[s.noke71]

Hi Guys,

i have  a simple part when i noticed i was producing a slot in the y axis not the x axis i have tried to re orientate my axis.

However it messes with my turning paths, they no longer work from the end of the model but 3mm further up the component. its very frustrating.I dont want to start again i just want to switch axis.

 Has anybody came across this before?

S

[ivan.stanojevic]

Hi,
It is really hard to say what went wrong without looking at the actual part.
Could you upload your part so that we can check on it?

[s.noke71]

Can do Ivan, How is it done?

[Laurens-3DTechDraw · Accepted solution]

Turn spun profile on in your setup and the turning paths will go back to normal.

[s.noke71]

Thank you Laurens. Worked fine