Ramp and Vertical Surfaces

[vid.kok]

My question is about Ramp operation. A section of the part doesn't have a tilt angle so the toolpath won't go fully around the part. Is it even possible to machine vertical surfaces with Ramp?

With tilt angle:

Without tilt angle:

I attached the part.

[Tianq]

@vid.kok,

I removed the selections of Machining Boundary in that operation and the toolpath generated is shown as below.

[HughesTooling · Accepted solution]

You might see this in a design where you want to use boundaries, all you needed to do was add a small additional offset, you had tool outside but you need a bit more like 0.1mm.

Mark

[vid.kok]

@Tianq the boundary needs to be as it is.

@HughesTooling, that worked perfectly! Thank you!