Post Processor ( END OF GROUP )

[nmccarvill]

I am using a modified post processor on a DMG Mori DMC 65 Monoblock. During the program it always says ( END OF GROUP ) when the next process is about to start with a different tool. I was wondering if this was a problem with the post processor and how to get rid of that. I have attached the post processor I am using currently below. Thank you. 

[Anonymous]

Do you do the editing yourself? In visual studio code?

[serge.quiblier]

Hello @nmccarvill 

We don't use this command in our geneirc posts.

So we can't give you any informations about this.

Looking at a Siemens 840D manuel, it look like a valid Siemens command.

But there is not a lot of explanation in the manual:

Regards.

[steveCSNTC]

where did you guys get the post? Reseller or home brew?