What does this particular options (angle) do? In my model, it doesn't seem to do anything.
Feed opt. is only working here because of the reduced feed radius. I am wondering if this is an Either-Or type of thing?
Feed Optimization options
When in effect it will show the toolpath slow in a yellow portion like this:
Oddly enough I see results with your settings in this model when I set the angle of the corner to 104°, albeit a very small reduction:
For a better result I would add a fillet equal to the radius of the tool, or preferably larger so the tool does not wind up in a full engagement cut.
If you uncheck the "Inner Corners Only" option you will be able to set a distance from the Radii that will also be done at the reduced feedrate, it is odd wording to me anyway, it is saying that only the Radii will be reduced feedrate 🙂
This keeps popping up due to the terminology used, hope this helps 🙂
Stay Safe
Regards
Rob
