extra stock needed for corners

[magpiemachining]

Hi folks any one have any idea why i am having to leave more than .008 on the tool radius before these corners can clean up? the sides do but not the corners

[daniel_lyall]

What setup and toolpath

[magpiemachining]

mill op1

[daniel_lyall]

I am not seeing anything really wrong at all.

Toolpath?

Screenshots or screencast?

[magpiemachining]

we either, the smoothing was at .004 before i changed it but no response from the path. i still had to leave more stock. the sides would clean up but not the corners. 

[daniel_lyall]

Are going by the sim in fusion or a backplot?

[magpiemachining]

can you explain what you mean? i am going by what happens in the machine

[daniel_lyall]

Some people see a simulation of the tool paths in fusion and it looks wrong but is a graphics error and say something is wrong with the toolpath bla bla and it is not if you check the toolpath on the machine or in a backplot.

What machine are you using/controller 

There have been problems with using smoothing in the past try with that turned off.

One thing that helps with finding problems is looking at the compear and edit and looking at view toolpath these are both in the right-click menu.

[magpiemachining]

there has been smoothing issues with the milltronics machine. several times we had a path violate a mold surface. the machine we are using for this part is a Mori mv50 with a msc500 fanuc control