I am attempting to set up my mill to use a 1.0mm flat Endmill. Everything is fine when i set it up to use the 3.5mm but as soon as i step it down to running with a 1.0mm, I get: "Error: Internal CAM kernel error. Please report through your support channel." which isn't exactly explanatory.
I have attempted to modify the setup with no success and I cant seem to find anyone else having similar errors. Any help would be greatly appreciated.
Be a lot easier to help if you share the design as an f3d.
Some of these setting look odd. Stock Contour might be wrong. I would think just one outside profile. Rest machining adjustment offset seems too big, try 0.1. As this is a 3d op you might not need stock contours and rest, rest on its own might be all you need. If this doesn't help share the design.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
