Compare and Edit: Not updating with the changes

[FrodoLoggins]

Toolpath doesn't regenerate after clicking "Yes", only regenerate manually:

[a.laasW8M6T]

Yea I find this annoying also as I quite often have to change the surface triangulation tolerance to get good toolpaths, then wonder why it didn't change anything.

I still don't know why its set to that default value(surface triangulation), in my experience it doesn't add much if any time to toolpath calculation.

[seth.madore]

I've seen this before, I'm not sure of the cause. The good thing is, once you've set your Triangulation Tolerance, you can right click on it and select "Save as User Default". Personally, I have all my 3D toolpaths setup with a very fine tolerance value, thus never needing to change it later.