Chamfer path G3.4

[kretallick144]

Had an issue with my Mill not accepting  the G3.4 code.  In chamfer path, if i eliminated the the lead in/out  i avoided the issue.

With lead in/out enabled it would chamfer one hole but stall on the next identical hole because of the G3.4

Is there a reason this happens?   Robodrill Post processor.

[Arun.rs]

HI @kretallick144 

Thanks for raising your concern via Forum.

The G3.4 is 3-D circular interpolation.  You can disable this by setting the following property.

Hope this helps!

Regards