Can't select top height or bottom height on heights tab for 2D pocket.

Anonymous · ‎02-04-2016

I Can't select top height or bottom height on heights tab for 2D pocket.

I just did it yesteday and now I can't. Must be a bug in the new update. My endmill is just cutting air for a long time because I can't adjust the top height down to the lower pocket.

HughesTooling · ‎02-04-2016

One thing to check, go to the model workspace and check what selection filters you have set.

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

Anonymous · ‎02-04-2016

All except Select Through

HughesTooling · ‎02-04-2016

Make sure all the sketches are off, I've found you can't select through a sketch boundary.

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

Anonymous · ‎02-04-2016

That did it! Thanks!

Community

Can't select top height or bottom height on heights tab for 2D pocket.

Can't select top height or bottom height on heights tab for 2D pocket.

Can't select top height or bottom height on heights tab for 2D pocket.