CAM / Spiral / Machining boundary selection 1 out of 8 selections not selectable

[karl.ri]

https://a360.co/2qwu2PI

I am not able to select the boundary for "Spiral 2 / 3". All other Spirals working fine.

The right closed contour is not available and "open contour" is not possible here.

The corresponding face is selectable in Design mode, so the contour should be available in CAM mode too.

What's wrong with my design or with F360?

Regards from Austria,

Karl

[Marco.Takx]

Hi @karl.ri,

I did a quick check and in my PC the boundary was selected??

Did the selection again and also selected the side wall as avoid.

Can you check my version?

If my post answers your question Please use  .Accept as Solution & Kudos This helps everyone find answers more quickly!

[karl.ri · Accepted solution]

Dear Seth,

your screencast did it. I used the selection tool in the wrong way.

XMas cookies may come (see bowl.jpg) .

Thank you very much for your quick and successful help.

Best regards,

Karl

[karl.ri]

Hello Marco,

I learned from Seth's screenxast how to use the select tool correctly. That solved my problem.

Thanks for your help anyway.

Regards,

Karl