Boxford VMC 300 post prosessor for Fusion 360

[jorn_andersen2HDAJ]

Does a post processor exist for a Boxford VMC 300 mill for educational training? 

[seth.madore]

There is only a post for the V10

It's likely that the post will work, in general, but may require modification for optimal success.

[jorn_andersen2HDAJ]

Thanks, then I will check it out ##- Please type your reply above this line
-##


Med vennlig hilsen
Jørn Kenneth Andersen
Kontaktlærer, Teknologi og Industrifag
Tryggheim Forus vgs

Tlf 996 91 764