Board outline messed up after deriving from enclosure and pushing from 3D to 2D board

xpuipc · ‎04-20-2022

Hi,

i am trying to derive an outline from enclosure following this Blogpost: Using Edit in Place to Synchronize Between ECAD and MCAD Designs

1. Create an rectangled board in electronics => Ok

2. Insert this into my design and project an new geometry as described with edit in place => OK

3. Finish this as described, board looks according to desired geometry (outline) => OK

4. "Go back" to electronics and check the board there => all fine => OK

5. Now push it back to 2D (3D => 2D) and then the outline get messed up => NOK

6. Detail when i click on the "outline" => NOK

7. More detail => NOK

8. When i push 2D=>3D the corrupt/messed outline gets filled in the 3D board view.

So please help, i am stuck in my project now...any advice helpful (workaround, fix, etc.)

Thank you

panpan_fan · ‎04-21-2022

I hope you are doing well!
Sorry for the mess up issue.

Would yo mind sending me your file to double check it?

I will send you my email address as a private message.

Regards,

Panpan Fan