Recovery file error
Hi @scott.norman,
I hope you're doing well. This is actually a nuisance error, basically Fusion360 waits for no commands to be active to do recoveries. Because in Electronics there is always a command on, this pops up every once in a while. It can safely be ignored. We're working to improve that.
Best Regards,
Jorge Garcia
Product Support Specialist for Fusion 360 and EAGLE
Kudos are much appreciated if the information I have shared is helpful to you and/or others.
Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
I hope you're doing well. This is actually a nuisance error, basically Fusion360 waits for no commands to be active to do recoveries. Because in Electronics there is always a command on, this pops up every once in a while. It can safely be ignored. We're working to improve that.
Best Regards,
Jorge Garcia
Product Support Specialist for Fusion 360 and EAGLE
Kudos are much appreciated if the information I have shared is helpful to you and/or others.
Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
