Highlight airwire using Show command not working

[furaTT4KY]

Hello, there is a bug: in the electronic design, it is not possible to highlight airwire (board routing) using the Show command. Airwire cannot be selected at all using the Show command.
Please correct it. Eagle did it perfectly.

____

One suggestion for improvement: it is much more efficient to use the 'Show @' command instead of the Show command. Can you add this as another button next to the Show command?

It is possible to define your own shortcuts for custom commands such as 'Show @'.?

[jorge_garcia · Accepted solution]

Hi @furaTT4KY,

I hope you're doing well. Take a look at your selection filter, by default the airwires are not selectable which avoids selection full of airwires you are not interested in picking. If you want to select them you can just include airwires in the selection.

In regards to shortcuts it is possible to make them using the Shortcuts command on the top right of the design toolbar. I hope this helps.

Best Regards,