Fusion 360 Electronics - DRC Problemas with unrouted wires identification

[Kristey]

Hello.

Hi have a project with GND poligons unrouted.
But after run DRC I didn't have any advise about that.

After compare some settings, I figure out my thermal width settings was tiny, if I change thermal width to 0 or encrease the size I solve the problem, however, this is a fail of design rule check (unrouted signals). I should be advised after run DRC.

[Kristey]

UP

I think this problem needs atention from Autodesk support team ...

[jorge_garcia]

Hi @Kristey ,

I hope you're doing well. Could you upload the file or something representative so that we can analyze it? This is definitely something that should be cought by the DRC.

I'm going to DM you my e-mail in case you don't want to post the files publicly.

Let me know if there's anything else I can do for you.

Best Regards,

[jorge_garcia]

Hello @Kristey ,

I hope this message finds you well. I haven't received the files yet and we really want to dig into this. Let me know if you need me to resend you my e-mail.

Best Regards,

[Kristey]

Send it now

[panpan_fan]

Hi @Kristey 

I hope you are doing well!

Today we release Fusion 360 V2.0.10806 and the issue should be fixed now.

Please have a try, thanks a lot!

Regards,

Panpan Fan