Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Why I'm not seeing this rectangle center snapping point when snapping joints?

ezequielleonzybert
Participant

Why I'm not seeing this rectangle center snapping point when snapping joints?

ezequielleonzybert
Participant
Participant
0 Likes
Reply
269 Views
2 Replies
Replies (2)

ezequielleonzybert
Participant
Participant

Nevermind, I did it with construction lines

No, construction axes are not working with joints...
Is there any solution?

My workaround was to create a new componen inside the one with the rectangular slots and move this empty component to the position where 2 construction axes intersect...
very tricky, if there are a better approach I'd like to know. Thanks

0 Likes

g-andresen
Consultant
Consultant

Hi,


@ezequielleonzybert wrote:

Nevermind, I did it with construction lines

No, construction axes are not working with joints...
Is there any solution?


I show 3 in the screencast

 

 

günther

1 Like