Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Weird slashes in my sheet metal

1 REPLY 1
Back to Fusion Category
Back to Topic Listing
Reply
Message 1 of 2
Anonymous
248 Views, 1 Reply
‎01-01-2018 07:13 AM
‎01-01-2018 07:13 AM

Weird slashes in my sheet metal

I don't have any warnings in my sheet metal design, but these strange slashes appear. I attached an f3d of the model with the slashes.

bottom_blank v4.f3d
Report
0 Likes
Reply
1 REPLY 1
Message 2 of 2
HughesTooling
Consultant
in reply to: Anonymous
‎01-01-2018 08:11 AM
‎01-01-2018 08:11 AM

Your end face is at a 1° angle so your sketch and extrusion are at the same angle.

tool2.png

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


Report
0 Likes
Reply
Reply

Forums Links

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Technology Administrators


Autodesk Design & Make Report

Report a website issue