Weird edge left after modeling

Weird edge left after modeling

Anonymous
Not applicable
560 Views
2 Replies
Message 1 of 3

Weird edge left after modeling

Anonymous
Not applicable

Have this weird ledge left over when I modeled this part, can't figure out how to get rid of it.

 

I removed .004" from the edge of the block to allow for some clamping on the part I'm trying to hold.

0 Likes
Accepted solutions (1)
561 Views
2 Replies
Replies (2)
Message 2 of 3

Anonymous
Not applicable
Accepted solution

Fusion was extruded right what you selected. You selected face profile excluding vases cuts. Here is the screencast how to achieve what you want.

0 Likes
Message 3 of 3

Anonymous
Not applicable

AHHHHHHHHHHHH, ok I couldn't figure out how to select those faces.  Turning on the sketch worked, thank you.

0 Likes