URGENT!! SNAP CLIP DESIGN

[Anonymous]

Hello!! I need a Fushion360 design of snap clips which are found in baby clothes (see photos attached). Diameter must follow the T-15 guidelines (12mm). I would also like for the caps to be as flat as possible!! I am not that experienced therefore can't design it myself. Is there anyone that already has a design or is whiling to help me out! It would mean a lot! 

Thanks!

[daniel_lyall]

https://www.youtube.com/results?search_query=fusion+360+revove

https://www.youtube.com/watch?v=HVEaYfdsgXc

https://www.youtube.com/watch?v=1KHvJqKFS1Q

These will help you learn what to do.

[daniel_lyall]

https://www.youtube.com/results?search_query=fusion+360+revove

https://www.youtube.com/watch?v=HVEaYfdsgXc

https://www.youtube.com/watch?v=1KHvJqKFS1Q

These will help you learn what to do.

[wmhazzard]

If you sketch the cross section of the clips, you can do a revolve and model the clip in one operation. 

[chrisplyler]

---

@wmhazzard wrote:

If you sketch the cross section of the clips, you can do a revolve and model the clip in one operation. 

---

Presumably, there would be a desire to have each part be a separate Component. So you could use a single sketch, but four separate Revolve operations.