Unable to add a chamfer to lettering

[xondat]

Hi,

I am unable to add .1mm chamfers to the letters R, B, and D in the attached picture. I've been able to add chamfers to the rest of the letters. The internal corners are 1mm fillets. Any help would be appreciated. 

Thanks.

[xondat]

Internal corners are actually .1mm, not 1mm. MB.

[TheCADWhisperer]

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

[xondat]

Attached.

[TheCADWhisperer]

Was it your design intent to have the R, B and D deeper than the rest of the letters?

They are .35mm deep while the rest of the letters are .1mm deep.

Is there a reason you are not recording the feature history?

It is unusual to thread counterbored holes.

Looking at the part - I would expect these to be clearance through holes and the thread to be on the mating part.

[xondat]

Oh I have them at .35 as I having trouble adding a .1 chamfer to a .1 deep letter (so I was raising it after the chamfer). 

No reason, not sure how to.

Is there a reason why I can't chamfer .1 the letters?

[xondat]

Looked around some more and no one can figure it out so the problem still persists - no idea honestly.

[TheCADWhisperer]

---

@xondat wrote:

.... - no idea honestly.

---

I recommend that next time you record your history.

Download attached.

File>New Design from File.

[xondat]

Thank you very much!

How did you do it in the end?