The configuration table does not display configurations correctly

[marcus.toepke]

Hi all!

I've noticed that when you use configurations and eventually end up with a lot of them, they don't display correctly in the table.

When I scroll down, the last configuration appears briefly, but then gets pushed back down again! I have to start scrolling all over again to see the last configuration, and then it disappears again, as if pulled by a rubber band.

[TrippyLighting]

I have reposted in the EE Slack Channel to give it more visibility!

[marcus.toepke]

Thx!

But what is a EE Slack Channel?

[TrippyLighting]

Autodesk Expert Elite Slack channel. It allows Expert elites direct access to the development team.

I often post bugs there that I cannot post here on the forum, as all of my professional work in the manufacturing automation industry is under NDA.

BTW, the topic has received some attention there.

[abhijeet.rajput · Accepted solution]

Hi Marcus,

Thanks for reporting. 

We have already fixed the issue and we expect to get the fix out in May Release of the Fusion. 

Regards,

Abhijeet Rajput

Autodesk Fusion.