Message 1 of 7
Split Body Using Profile - Error (possible bug)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hi
I am making an outside door. I have the basic dimensions in place and now want to separate the body out to separate components using a (2 segment) line to work on the mortice and tenon joints.
Now if I select my required profile and leave the 'Extend Splitting Tool' enabled the cut is performed as expected. if I disable it and try again I get an error message 'Cannot compute' no intersection. The points I chose were produced by the project command.
The split lines are on Sketch 3, converting the square 'figure of 8' into 5 bodies
Thoughts or solutions most welcome
Thanks