Show Profile is checked for a sketch that should be closed but it will not highlight to be extruded

Show Profile is checked for a sketch that should be closed but it will not highlight to be extruded

glmeadows
Participant Participant
116 Views
2 Replies
Message 1 of 3

Show Profile is checked for a sketch that should be closed but it will not highlight to be extruded

glmeadows
Participant
Participant

I have a sketch that seems like it should be closed but when I select Show Profile in the Sketch Pallete, it does not highlight and I am unable to Extrude.  See attached f3d file.

0 Likes
117 Views
2 Replies
Replies (2)
Message 2 of 3

glmeadows
Participant
Participant

This has been resolved.  I regret bothering the forum but after 4 hours of problem examination, I thought I'd check with the experts.

 

0 Likes
Message 3 of 3

TheCADWhisperer
Consultant
Consultant

@glmeadows 

White points are unconnected.

White points and blue curves should keep you awake at nigth.

Make use of obvious symmetry about the Origin.

I am certain the issue has not been resolved.

0 Likes