Sheet metal Bend Radius End?

[Chandler_Gaines]

First time post so hopefully in the correct spot and whatnot...

I have this three sides sheet metal part, Two outer sides are flat, but I want the center piece to have a radius.

I can bend the outer pieces just fine, but when adding a bend in the center for the radius it also applies that radius to the already bent (flat) sides.

How to I avoid that?

Thanks in advance

[TheCADWhisperer]

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

[Chandler_Gaines]

Unfortunately, I cannot....Company Policy.