Announcements

Starting in December, we will archive content from the community that is 10 years and older. This FAQ provides more information.

Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Red Mark on sketch in browser

2 REPLIES 2
Reply
Message 1 of 3
Anonymous
1405 Views, 2 Replies

Red Mark on sketch in browser

What does the red mark on the sketch mean? It disappears when I remove a dimmension, but without that dimmension I believe the sketch is underconstrained (some of the lines are colored blue).   I have the preview feature "color sketch geometry based on constraint status" turned on.

 

See the attached screen shot for the red mark:

AutodeskFusion360-RedMarkOnSketch.png

 

Also, are the colors that the constraint coloring uses documented anywhere?

 

Thanks.

 

    --- Carl

 

2 REPLIES 2
Message 2 of 3
jeff_strater
in reply to: Anonymous

That little icon is a push-pin.  It indicates that this sketch is fully constrained.

 

As for the sketch colors, it depends on the environment you use.  For the "Grey Room" environment, which I use, these are the colors:

 

sketch colors.png

 

Jeff Strater (Fusion development)

 


Jeff Strater
Engineering Director
Message 3 of 3
Anonymous
in reply to: jeff_strater

Thanks. That's exactly what I needed to know.

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report