DXF Import from PADS PCB Failure

[Bud_Schroeder_ADESK]

Hi Nick,

Welcome to the forum, and thanks for posting your question to the A360 forum. It sounds like your question is for Fusion and so we are going to move this to the Fusion forum so that the team can help sort out this error.

Hope this helps get you pointed in the right direction and thanks for posting to the forum.

[Bud_Schroeder_ADESK]

Hi Nick,

Welcome to the forum, and thanks for posting your question to the A360 forum. It sounds like your question is for Fusion and so we are going to move this to the Fusion forum so that the team can help sort out this error.

Hope this helps get you pointed in the right direction and thanks for posting to the forum.

[ndprsha1]

I am trying to import a DXF file from PADS and it every time I try and upload it to lay into my design F360 says it failed to import.  I know there are some variances in DXFs depending on the exporting software, but this is just a 2d layout of a PCB.  This doesnt seem like it should be that hard to import.  I tired importing it as an image too, no luck.

[ndprsha1]

I am trying to import a DXF file from PADS and it every time I try and upload it to lay into my design F360 says it failed to import.  I know there are some variances in DXFs depending on the exporting software, but this is just a 2d layout of a PCB.  This doesnt seem like it should be that hard to import.  I tired importing it as an image too, no luck.

[inchul.lee]

Hello Nick,

Welcome to the Fusion 360 forum.

Would you please share your DXF file for our review? If you prefer, I can send you a private link where you can upload it.

Thank you.

[inchul.lee]

Hello Nick,

Welcome to the Fusion 360 forum.

Would you please share your DXF file for our review? If you prefer, I can send you a private link where you can upload it.

Thank you.