Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I can't figure why sometimes I can pull a point of a projected spline to extend it and sometimes not!
I do a sketch (with arcs and splines), extrude it to have a body; new sketch, project/include an edge, delete constrains for the end points (but not for the whole spline), pull a point and this extends the spline following its curvature: NICE!
Same thing but with another body and it does not work!
Might it be ok for the arcs, for example, and not for a spline?
Fusion
