Project a hole from an imported component onto a component

[rpsalas]

I am using an imported step file that has a complicated assembly (without sketches). This assembly has four holes. 

I want to place that assembly on top of a body in my design. 

And then I want to "project"? the holes from the assembly onto the body so that, if I move the assembly the holes will move too.

I think it must be a common requirement but I have not managed to do it yet, Thanks!

[TrippyLighting · Accepted solution]

What is your experience level with Fusion?

In the screen recording I show what I would do. For each new discrete part you'd create a component and then, with the component , start sketching and modeling that component.

To position and orient components you should use assembly joints.

[g-andresen · Accepted solution]

Hi,

try this

günther

[rpsalas]

Thank you both! That was super helpful. My level of experience (to answer your question) is about 1 month of pretty serious learning and experimentation. I am sure I am doing lots of things wrong! Folks in this community has been super helpful!