Possible to have more than one (modeling) fillet radius?

[Noah_Katz]

I like to keep the number of modeling steps to a minimum.

As far as I can tell it's not possible to have more than one (modeling) fillet radius in one fillet opeation

Is that correct?

[HughesTooling · Accepted solution]

I made this screencast a while ago for a request on the ideastation but it does show how to use edge sets.

[Noah_Katz]

Awesome!

It finally dawns on me that the little down arrow isn't just for show.

You'd think they'd mention that in the tutorials; if not then, when?

Thanks, Mark.

[HughesTooling]

I only found it after putting a request on the ideastation, someone from support pointed out it was already in Fusion. It got quite a few votes before support chimbed in so it's not very discoverable.

Mark

[Noah_Katz]

I sure wish AD would spend more time documenting, it would save so much user frustration and their time, as well as us questioners' and you answerers'.

[HughesTooling]

I guess both of us should be more observant. Although not the best explanation.

Mark

[Noah_Katz]

Apparently that's hit-or-miss; I just tried it and didn't get Tips, nor do I remember seeing it before.

Do you know what you did to get that?

[HughesTooling · Accepted solution]

I pressed the "i" then the + then the arrow next to Tips, you also have a more information button that takes you to the online help. Once you have the help tip expanded in Fusion it shows for all the tools in the model workspace.

[Noah_Katz]

Awesome, thanks, Mark!

When clicked on the i a small separate window popped up at the far upper left of the screen.

Fortunately I learned here https://forums.autodesk.com/t5/design-validate-document/the-browser-got-unstuck-from-the-canvas/td-p... that dragging it over the fillet window docks it to it.