Hi,
I am trying to draw a sketch based on some calculations i do within my parameter list.
I drew a component wich is 7mm thick, 150mm high and 471,239mm long. this part is curved with a radius of 600mm. I converted it to sheetmetal, made a flatpattern. Then when you openup the parameter list it is completely empty. If you make a scetch you can't even open the parameter list. What is the reason the list doesn't show up in flatpatern?
Thank you in advance
Solved! Go to Solution.
Solved by TheCADWhisperer. Go to Solution.
I am not at my Fusion machine to check - but shouldn’t you be in Unfold rather than Flat Pattern?
It is exceedingly rare to be editing anything in Flat Pattern state.
Can't find what you're looking for? Ask the community or share your knowledge.