Need Help Adding Back to Keychain

Need Help Adding Back to Keychain

Anonymous
Not applicable
429 Views
2 Replies
Message 1 of 3

Need Help Adding Back to Keychain

Anonymous
Not applicable

I found a keychain I'd like to use in STL format but I need to add a back to because as it stands the 3d printed emblem that I'd like to snap into the center keeps falling out. I've imported the STL and converted the mesh to BRep but not sure where to go from here. I've tried to use the offset and face tools without success. I've attached the STL for reference. Any help is greatly appreciated!

0 Likes
Accepted solutions (1)
430 Views
2 Replies
Replies (2)
Message 2 of 3

etfrench
Mentor
Mentor

In the Surface workspace use the Patch command then Thicken to fill it in.

ETFrench

EESignature

Message 3 of 3

TheCADWhisperer
Consultant
Consultant
Accepted solution

For geometry that simple - I think I would remodel from scratch.

I think you will be happier with the quality of the results.