Move a "derived sketch"

[sandeepdutta]

Is there a way to move a derived sketch ? I need to a create a single component 

with two instances of a derived sketch . Any solution would be appreciated.

Thank you

Sandeep

[HughesTooling]

Create a component and with it active insert derive the sketch. Now you can position the component with a joint to move the sketch to the correct point.

Mark

[sandeepdutta]

Thank you, that worked. The quirk is that is does not derive the parameters if component is active, but

I derived another one at the top level to get the parameters and that worked as well.

Sandeep

[HughesTooling]

---

@sandeepdutta wrote:

Thank you, that worked. The quirk is that is does not derive the parameters if component is active, but

I derived another one at the top level to get the parameters and that worked as well.

Sandeep

---

Yes, I ran into that problem a few weeks ago, took me a while to figure out what the problem was!

Mark