How to turn the origin

[Anonymous]

Dear all,

could someone explain please how I can set the angle of the origin so that it is equal to the sketch itselft?

That would be really great!

Thank you so much for all your comments!

Best regards,

Sven

[Brady_Fulton]

https://knowledge.autodesk.com/community/screencast

[Anonymous]

@Brady_FultonThank you!

[Anonymous · Accepted solution]

Dear all,

the solution for my problem was completly different. The reason were different messearing units in F360 and my control software WinPCnc. In F360 I use as measuring unit mm/min in WinPCnc was mm/sek adjusted. After I adjusted mm/min also in WinPcnc everything worked fine.

Thank you for all the comments again and best regards,

Sven

[daniel_lyall]

@Anonymous mark your last post as solved you supplied the answer