I'm trying to design the neck of a soap dispenser. I found the spec in the 4th page of this document: https://www.thecarycompany.com/media/pdf/specs/68W26B.pdf. I created the thread, but it starts and end on a wall, not a smooth transition from the shaft:
How can I make it start smooth, emerging from the central shaft?
Here's my model: https://a360.co/3r2JSAK
Solved! Go to Solution.
Solved by MRWakefield. Go to Solution.
The way I do it is this:
See attached.
Hope this helps.
If this answers your question please mark the thread as solved as it can help others find solutions in the future.
Marcus Wakefield
Can't find what you're looking for? Ask the community or share your knowledge.