Help with sweep (I think?) along curve

[ltryon1]

Not sure what I'm needing to do here. Electrical drafter at work, just started messing with 360 for fun. I'm needing to scallop the curved surface at a 19.5 degree angle the entire length of the piece. Various sweep attempts have got me close, but nothing I've tried completely works. Any help would be much appreciated thanks!

[davebYYPCU]

Looks concentric to me, sketch the side panel, and Revolve 19.5 degrees.  I will check the file later.

Might help.....

[TrippyLighting · Accepted solution]

That curved surface is created form an imported sketch . The individual sketch objects are only near tangent, but not fully tangent toward each other. If you re-draw that curve with a fit point spline (should not require more than 3 fit points!) then the sweep will likely succeed.

I would also recommend that you fully define (constrain and dimension) all non-spline sketch objects.

[ltryon1]

---

Thanks! The problem was the curve I imported from inkscape. Following your advice, I re-imported the curved path, traced with 3P spline, deleted import. After that I was allowed to sweep with path+guide rail and accomplished exactly what I was trying all day to do!