Expanding a line circular?

[Anonymous]

Would like to get a circle to extrude centered on these six lines or spokes.  Need to create and manipulate cylinders radiating out from the side of this cylinder...

thanks!

[JDMather]

1. Assuming the Origin is at the center - create a circle on one of the planes going through the origin and then Extrude.

Pattern the Extruded cylinder.

2. Another option would be to sketch a Rectangle and Revolve the rectangle.  Then Pattern the revolve cylinder.

File>Export and then zip and Attach your *.f3d file here if you can't figure it out.

(You might not need to zip if the forum has been fixed.)

[etfrench]

If the cylinders are not identical, then create a sketch on each line by starting with the 'Plane on Path' command.

[g-andresen · Accepted solution]

Hi,

here is one way to realize it.

günther

[Anonymous]

This community is just amazing!! Thanks so much.

[mavigogun · Accepted solution]

Be sure to Accept the solution- otherwise, folks will think there is still help needed here, spend time where it is no longer needed.