@ClintBrown3D Is there any way to add angular dimension more than 180°? Similar to baseline dimensions but for angles.
I'd like to be able to dimension then next 2 of 216° and 288°. I need to set some parts up on a machine using a round table type setup on an EDM machine. I also need to set the angle the machine with cut so although I can work these out it would help if I could actually have the angles on the drawing. This is part of a 2 cavity mould and the other side is rotated 180° so it's going to be easy to get confused if I need to work this out rather than have it on the drawing.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Solved! Go to Solution.
Solved by ClintBrown3D. Go to Solution.
Yes. Use the Angular dimension tool. Follow the tooltip prompts.
In the animation below, I am pressing the spacebar then selecting the intersection of the angled lines then points at either end.
Can't find what you're looking for? Ask the community or share your knowledge.