Message 1 of 10

Not applicable
02-12-2020
05:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hi guys i've been asked to etch a 3D linedancer/cowboy boot within a glass keyring but they have given me a specific boot design to copy. I'm not sure if its even possible in fusion or requires different software? whether there are people who could do it for me or, if it is possible to do, you think a fairly newbie to fusion like myself has any hope of designing this myself?
Solved! Go to Solution.