Cut Simple Sketch Curve

[MaxHugen]

Must be the dumbest question I've ever asked, sorry, but how to you cut a simple spline curve into two?

Just draw any simple Fit Point Spline curve, then cut it in two, anywhere!

Dr Google is presenting me with all these much more complex examples of cutting - but not an absolutely basic method!

[TheCADWhisperer · Accepted solution]

[MaxHugen]

Thanks.   However I wasn't expecting this to do a Delete as well.   I should have been more explicit - I actually need to cut a curve in two places, then delete the middle piece leaving the two outer pieces intact.

[MaxHugen]

All good, thanks. I should have been searching for "Break", not "cut" !

[TheCADWhisperer]

---

@MaxHugen wrote:

  I should have been more explicit - I actually need to cut a curve in two places, then delete the middle piece leaving the two outer pieces intact.

---

Uhmmm. That would be Trim.

[MaxHugen]

Yes, it worked OK with Break, but would have been simpler with Trim, now that I've read up on it. 🙂

22 days with F360, still a lot to learn!