Creating internal tapered tube (f3d attached)

[877cms]

Good afternoon, 

Could anyone advise if there is a way to create this internal taper, so that the bottom part is at the inner circle of sketch2 (indicated by red arrow). Currently I can do it by trial and error, adjusting the draft angle to -1.5 degrees, but I think there may be a better way.

[jeff_strater · Accepted solution]

here is one way, using Loft:

[g-andresen]

Hi ,

try this

Screencast

günther

[jeff_strater]

here is another way, using Revolve:

[877cms]

Seems @jeff_strater and @g-andresen had the same idea, thank you both. I tried that myself and it works and is easy to remember 🙂

I'll look at the revolve method, but honestly I'm best not confusing myself!

Thanks