Creating a V shaped part

[Pillnoob]

I have been working on this project for quite some time with no luck. I have tried placing two "flanges" in space and creating a loft and just cant seem to make it work. My first question is how do I place a point in 3d space? Attached are some pictures of a billet piece, like I'm trying to make, a weldment (that I have made) and a oem casting of the part I do not need to cad up the feed tube yet just the cross section itself.

Any help is appreciated thanks

[Pillnoob]

The two flanges are staggered and I must maintain the right length from bolt hole to bolt hole.

[Beyondforce]

Hi @Pillnoob,

Welcome to Fusion 360.

You attached several picture and I'm not sure, which of them are you trying to make. It will be best, if you could make screencast and show us what exactly are you trying to make and what doesn't seems to work for you.

Cheers / Ben
---------------------------------------------------------------------------------------------------------------------------
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

Check out my YouTube channel: Fusion 360: Newbies+

[Pillnoob]

As stated in the first post I am trying to make one like the billet aluminum picture.

[Beyondforce]

I hope that's what you are looking for:

Cheers / Ben
---------------------------------------------------------------------------------------------------------------------------
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

Check out my YouTube channel: Fusion 360: Newbies+

[Anonymous]

I did a rough mockup pipe loft

beyondforce has a nice detailed video .

[Pillnoob]

I need to maintain 40 degrees and control the distance from each upper bolt hole to the other. I am trying to make this out of billet so minus the round tube it will be machined from a square block good starter video but I am having trouble with bolt hole spacing side to side.

[daniel_lyall]

@Pillnoob Thats not to hard to do can you post your fusion file