Creating a drawing template: Snap grid won't let text be flush?

[FrodoLoggins]

Sometimes text/attributes snap to where they should be, sometimes I'll get things just right/change my mind/then I'm unable to put the text back to where it was, it's really just trial and error.

Right now I'd like these two texts to be on the same horizontal plane, but Fusion just won't seem to let that happen:

Then there are times like this where I'll move text/image/attribute to a snap point, but when I take my finger off my trackpad the image doesn't land where it snapped to. Shown below over and over again I'll move the image to a snap point but it shifts over to the left a bit:

[ClintBrown3D]

Hi @FrodoLoggins 

Here are a couple of tips and tricks in the title block editor that should help (see video).

For your image, I would use the move command, similar to text int he video: