Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Can you slide a joint with a round corner, i am searching but can can't find it?
Can you slide a joint with a round corner, i am searching but can can't find it?
If you make a joint with a slider, is it possible to slide with a guiding line, i tried, but only horizon and vertical ways, it doesn't understand bending? Is that posibble?
@manomano74 you can't get a joint that follows a straight then curved path so far as I know. You can however turn on "Enable All Contact" under the Joints menu and manually shift the components - helps if one of them (in your case the pipe) is "Grounded" first. This isn't very useful but if all you need to do is capture some positions for images or drawings then it could work. Would be quite fiddly though and there needs to be enough wiggle room between the two objects and would help if there are enough constraints to stop it getting twisted and the likes....
This would be a good submission for the IdeaStation (if there wasn't one already - something like "Sliding Joints along Path"
Fusion
