Basic Drafting Issues

[Anonymous]

Hi  I have submitted part of this concern to support but have found to many issues beyond the one that I submitted.

When doing a medium difficulty drawing I have found numerous problems that I hope someone else has seen.

Create a center-line through a angled hole - cannot select the 2nd edge (this one is weird, I need a new model to confirm repeat-ability)

Cannot dimension a line to a point

Cannot create an aligned view to a feature - like a hole on an angle to it can be located

Dimensions do not stay associated to the feature, edge or end point when model is modified

Cannot apply a dimension to intersections of center-lines that do not loose association immediately

I will provide a screencast later tonight when I have a moment to create a model to demonstrate the issues.

[robduarte]

Screencasts are helpful. You'll probably have better luck getting answers if you post each problem separately. It's also useful for people who have the same/similar problem in the future since you can mark an answer as a "solution".