Auger flight flat pattern

[benzlerW44MW]

Hi guys,

First post here. Please be gentle.

I am trying to convert from Inventor to Fusion and now I am stuck at creating a flat pattern for a screw conveyor auger. I can draw it similar to how I did it in Inventor - by creating a surface loft between two coils (instead of spirals) and thicken it but when I try to convert into sheet metal it fails. Fusion "can't calculate body thickness".

Any advise? Screenshot from Inventor below.

Edit: attached Fusion design

[g-andresen]

Hi,

please share your design.

günther

[benzlerW44MW]

Hi, added design now.

[g-andresen]

Hi,

---

@benzlerW44MW wrote:

Hi, added design now.

---

Where?

günther

[lichtzeichenanlage]

1st post

[benzlerW44MW]

It's attached under the inventor image. Attaching it here as well.

[Beyondforce]

Hey @benzlerW44MW ,

I hope this will help you:

https://knowledge.autodesk.com/community/screencast/ccbf9032-2e36-42bd-9d33-42a4c9e628bf

Cheers / Ben
---------------------------------------------------------------------------------------------------------------------------
Did you find this reply helpful? If so please use the Accept as Solution or Kudos button below.

Need a new computer? Fusion 360 Hardware Benchmark: TESREG.com
Check out my YouTube channel: Fusion 360: NewbiesPlus

[davebYYPCU]

Did you read the question?  I watched to the end, maybe you have 2 videos?

Maybe the next one for the answer? please.

[Beyondforce]

Yep, it was my mistake!
I have checked the sheet metal issue, and I couldn't do it as well. So I tried another twisted shape and it didn't either, so I'm guessing it's either a bug or a limitation.

[davebYYPCU]

Slept on the problem, overnight I remembered this one, 

Meshmixer fix 

Message 2, will get you there, I think.

Edit; Worked for me, tip - extrude the plate in Mesh Mixer, so the there is thickness to section with fit curves to section back in Fusion....

Might help....