arc/fillet problem

[Anonymous]

Fillet works on lines but not arcs.

See screencast

  https://screencast.autodesk.com/main/details/5ee54452-4fbc-4496-81e4-e12b414fcb29

Note pop-up box which says "fillet cannot be created"

[jiang_peng · Accepted solution]

I think it's a bug. We will log it and start to investigate.

As a workaround, please see following steps:

 

Now the fillet:

[jiang_peng]

Bug logged as FUS-19601

thanks

[Anonymous]

This still seems to be a problem.

I don't appear to be able to creat a fillet from an arc that has any kind of constrants.

If i make 2 arcs in the middle of no where connected to nothing else I can can use the fillet comand on them no problem but as soon as I draw an arc conected to other elements the fillet comand stops working even if it's between an arc and a straight line.

[jiang_peng]

Could you please post a screenshot of the new found issue?

Thanks!

[Anonymous]

Good morning Jiang Peng from New Zealand.



There is a screen shot already posted with respect this problem.



If you need to repeat the problem, just draw two arcs. Then try to put a
fillet across the ends of them. For example an upper and lower airfoil arc
cross-section with a radius leading and trailing edge.



Good luck




Stuart Reid B E (Mech) N Z C E (Mech)

Managing Director




_____





027 240 9691




04 586 3411




stuart.reid@spitfire.net.nz




www.spitfire.net.nz




421 Cuba Street
Alicetown
Lower Hutt 5010