Help! How can I get the Post output Tool List to the NC code File?

[greendhg]

See my post setup under the operation tab of the tool list. The NC output is what I get? 

 

[kandennti]

Hi @greendhg .

I may not be understanding your question.

It depends on the cps file, but if you turn on "Write tool list", the tool list will be written out.

[greendhg]

Thanks kandennti,

I''ll try to make myself clear. I do have my "write tool list" checked. The problem is that it doesn't write the tool list with the same description to the NC code.

Example of Tool 1 description;

#1-02" face (2" FACE MILL)

Example of output NC code file (read out) or (program sheet);

(T1 D=2. CR=0. -2 MIN=6.7129- FaceMill)

The NC code file is what the operators will see in the control panel screen at the machine. Nobody will understand the description of the NC file readout. How can I get the post to output the same description?

Thank You

[kandennti]

@greendhg .

If you have any questions about cps, you can ask them in the Fusion 360 Manufacture forum or the HSM Post Processor forum, where they are more likely to be answered.