Ramp angles are different

[FrodoLoggins]

Specified ramp angle: 45 degrees.

Some ramps are 45 degrees, some are more like 5 degrees.

[seth.madore]

This has always been a tricky one to get to perform proper. I find that by defining a start point on a long edge, I can get it to behave properly:

The dev I'd like to talk to about this is out (different time zone) so I'll raise this with them tomorrow

 

[DarthBane55]

or change the maximum ramp step down to something really big like 10".

[Imnotbobjonesautodesk]

AhhhH!!! Thanks @DarthBane55 !!! I only had to set maximum ramp step down to 1" instead of 0.25" and that made it work perfectly.

[programming2C78B]

The ramp will limit itself to your max stepdown, per complete revolution and 'ignore' the angle. It's always been like this.