Hello, Working out adding new things to my post processor for setup sheets in excel. mainly looking to automatically populate a few boxes with info from fusion:MachineNumber of offsetsWCS position relative to part.. this one will be tricky i think(top center, bottom back left, selection point?)Notesi am using the dumper post to look at all the parameters, but the parameters in the dump dont match the expressions in F360. I m just trying to connect the dots right now. i think all but the WCS position will be as easy as exposing the variables if not already exposed and then using them in excel.

Dumper file help (Post processor)

Community

Forums

Fusion Manufacture

Talk shop with the Fusion (formerly Fusion 360) Manufacture Community. Share tool strategies, tips, get advice and solve problems together with the best minds in the industry.

Message 1 of 1

222 Views, 0 Replies

Hello,

Working out adding new things to my post processor for setup sheets in excel. mainly looking to automatically populate a few boxes with info from fusion:

Machine
Number of offsets
WCS position relative to part.. this one will be tricky i think(top center, bottom back left, selection point?)
Notes

i am using the dumper post to look at all the parameters, but the parameters in the dump dont match the expressions in F360. I'm just trying to connect the dots right now. i think all but the WCS position will be as easy as exposing the variables if not already exposed and then using them in excel.